If you need a mobile auto electrician in Bunbury who works where the car is, that is what our mobile workshop is for. We bring the testing gear, find out why the car won't start and fix it on the spot where we can. A jump start gets you going once, but it doesn't tell you whether the battery, the alternator or a loose wire is the cause.
A mobile visit covers battery testing and replacement, charging system checks, fault code scans and wiring faults such as corroded terminals, weak earths and blown fuses. Some jobs need a part ordered or a workshop with a hoist and bench, and we say so before any work starts. If you've searched for a mobile auto electrician near me, we come to homes, workplaces and stopped cars across the city. Call 08 6706 6760 or send the quote form and tell us what the car is doing.
What we fix on a mobile call-out
Most car electrical faults can be found and fixed where the car is parked. These are the jobs we do most often on a mobile call-out around Bunbury, from a flat battery to a dash full of warning lights.
Flat batteries and no-starts
A jump start gets the engine running, but it doesn't tell you why the battery went flat. We load test the battery, check the charging output and look for anything draining it overnight. If the battery is finished, mobile car battery replacement means it's swapped on the spot and the old one goes with us.
Cars with start-stop systems need the right battery type and may need a reset afterwards, so we match both before we leave. If the battery tests healthy, we keep looking until we find what flattened it.
Charging faults
A battery light on the dash usually means the charging system has stopped doing its job, and the car is running off the battery until it goes flat. On site we measure voltage with the engine off, running and under load to see what the alternator is putting out. We also check the voltage regulator, the belt drive and the heavy cables.
A corroded terminal or a poor earth can mimic a failed alternator, so those get checked first.
Warning lights and fault codes
We plug an OBD scanner into the car and read the codes stored in the ECU. A code points to a circuit, not always to a failed part, so we then check the wiring, connectors and earths behind it.
Where the fault is a damaged wire or a bad connection, we can usually repair it on site and clear the code. Faults that need a module programmed to the vehicle are outside a mobile visit, and we tell you that straight away.
Lights, locks and accessories
Headlights that flicker, central locking that works on one door and power windows that stop halfway are usually a wiring, relay or switch problem. We trace the fault in your driveway or work car park and repair it there.
We also fit reversing cameras and dash cams at home or work, with the wiring run neatly and fused properly. Bigger fit-outs that need the car for a full day are better booked as a workshop job.
How a mobile call-out works
Every call-out follows the same four steps, so you know what is happening and what the job will cost before any parts go on the car.
- 1
Tell us where the car is
Give us the address or location, the make and model, and what the car is doing. Photos of the warning lights on the dash help us bring the right gear. If the car is on the road, tell us whether it is somewhere safe to work or needs moving first.
- 2
Test before replacing
We don't swap parts and hope. A battery load test, a charging voltage check, a scan for codes and a look at the earths tell us what has actually failed. A no-start can turn out to be a terminal or a cable.
- 3
Quote and fix on site
You get a written price before we start. When we can get the right battery, a battery job finishes on the spot. If a part has to be ordered, we explain what it is, how long it will take and make the car safe in the meantime.
- 4
Re-test and hand back
We start the car, let it run and re-test the charging and the fault that brought us out. Codes are cleared once the cause is fixed. The old battery goes with us for recycling, and we tell you what we found.
Want the fault found and the repair priced before any work starts?
Mobile or workshop: which suits your job?
Mobile suits most battery and wiring jobs. A few repairs need a hoist, a bench or a longer stretch of uninterrupted time, and it is better to know which is which before you book.
On-site mobile repair
Batteries, fuses, relays, wiring repairs, accessories and fault finding are all well suited to a mobile workshop. The car stays where it is, you don't pay for a tow and you can carry on with your day while we work. The trade-off is space and conditions. A wet car park, a cramped garage or a busy kerb can limit what is safe to do, and we may suggest moving the car or booking a different time.
Workshop or bench work
Alternator or starter motor rebuilds, jobs under the vehicle and large fit-outs need a hoist, a bench and room to lay out a loom. If the testing in your driveway shows the alternator or starter motor has failed, we can still quote the job and explain where it is best done. The trade-off is getting the car there, but for these repairs it is the safer and tidier way to do the job.
Mobile auto electrician work around Bunbury
Bunbury's urban population was 76,452 at the 2021 census. Greater Bunbury takes in the City of Bunbury and the Shires of Capel, Dardanup and Harvey, so the area is spread out and a flat battery can leave you a long way from a workshop.
Traffic moves in and out on the Wilman Wadandi Highway, which opened in December 2024 and links Forrest Highway to Bussell Highway. Forrest Highway itself runs up to the Eelup Roundabout in East Bunbury.
Between home driveways, work car parks and farm properties on the fringe, there are plenty of places where a stopped car would otherwise need a tow.
Safe, tidy work wherever the car is
Working outside a workshop still needs the same care. This is what we do on every call-out.
Safe on the roadside
If the car is on the road, we park to protect the work area, use hazard lights and keep clear of traffic. Where a car is in a live lane or on a blind bend, it has to be moved to a safe spot before we start. We would rather take an extra few minutes setting up than work somewhere that puts anyone at risk.
Correct battery for the car
The right battery matches the car's size, terminal layout and type, so we check all three against the old one before fitting. Standard, AGM and EFB batteries are not interchangeable, and cars built with start-stop generally call for AGM or EFB. After a swap we reset anything that loses its settings, so the car behaves the way it did before.
Recycling
Old lead-acid batteries are hazardous waste, so we don't leave them behind and we don't put them in the bin. We take the old battery with us for recycling after every swap. You don't have to find somewhere to drop it off or store it in the garage until you do.
What affects the cost of a mobile auto electrician?
Every call-out is different, so we quote the job rather than guess over the phone. A few things move the cost more than others. Describe the fault and where the car is, and ask for a free quote before any work starts.
Distance and location
Jobs inside Greater Bunbury are simpler to schedule than a call-out further out. Distance and access to the car both play a part.
The fault
Swapping a battery is quick. Tracing a drain or an intermittent wiring fault takes longer, and so costs more than a straightforward swap.
Battery type
Standard, AGM and start-stop batteries differ in cost, and the right one depends on what the car was built with.
Parts to order
A part we have on hand keeps the job to one visit. One that has to be ordered adds time.
Mobile auto electrician FAQs
Do mobile auto electricians charge more than workshops?
Mobile auto electricians can cost more or less than a workshop, depending on the job. You save the tow and the time without the car, but travel to your location is part of the price. We quote each job in writing before we start, so you can compare it with a workshop quote.
What vehicles can a mobile auto electrician work on?
A mobile auto electrician can work on cars, utes, 4WDs, vans and light trucks. Most battery, charging and wiring faults can be handled where the vehicle is parked. Heavy trucks and jobs that need a hoist or bench may have to go to a workshop.
Can a mobile auto electrician fix my car on the side of the road?
A mobile auto electrician can often fix a car on the side of the road, particularly a flat battery or a simple wiring fault. Safety comes first, so if the car is in a live lane it needs to be moved before we start. Tell us exactly where it is when you call.
What happens if a mobile auto electrician doesn't have the part?
If a mobile auto electrician doesn't have the part on hand, we order it and make the car safe in the meantime. Once the part arrives, we return to fit it, or tell you if the job needs a hoist or bench instead. We explain the options before you decide.
Can a battery be replaced at home or at work?
A car battery can be replaced at home or at work on most cars. We test the old battery first, fit the right type and reset anything that needs it, which matters on start-stop cars. The old battery goes with us for recycling.