Mobile auto electrician across Bunbury, Australind, Eaton & DalyellupCar won't start? Call 08 6706 6760
BunburyMobile Auto Electrician
Menu

HomeServicesCaravan & Camper Electrical

Caravan Electrician in Bunbury, WA | 12V, Solar & Lithium Upgrades

The van does not charge on the drive down the highway. The power points are dead when you reach camp, or the fridge flattens the battery overnight. These are the faults we get asked about most before a trip. As a caravan electrician and auto electrician in Bunbury, we trace them back to the cause rather than swapping parts and hoping.

Our caravan electrical work covers 12V fault finding, solar panels and regulators, lithium battery upgrades and inverter systems, for caravans and camper trailers. We fit gear from brands such as Redarc, Enerdrive, Projecta and Victron where it suits the van. We stay on the 12V side, and we say plainly that fixed 240V wiring in WA is for a licensed electrical contractor.

Before we touch anything, we test the charge path and the battery, so the quote covers the real fault. If the van only needs a fuse or a clean connection, that is all we will quote for.

Looking for caravan electricians near me? The van can stay parked at home while we test it. Ring 08 6706 6760 or send the form with the van's make and the fault.

Caravan and camper electrical work

Most caravan electrical jobs fall into a handful of groups, from a single dead circuit to a full off-grid upgrade. Here is what we do on vans and campers.

12V fault finding and repairs

When a van will not charge from the car, or 12V outlets, lights or the water pump stop working, the cause is usually a blown fuse, a loose connection or corroded wiring. We test the circuit with a meter and trace the fault to its source.

Caravan electrical repairs cover fuse panels, switch panels and damaged wiring, and we explain what failed and why, so the same fault does not return on the next trip.

Lithium battery upgrades

Swapping an AGM battery for lithium (LiFePO4) cuts weight and gives you far more usable capacity. It is not a straight swap, though. The charger, the solar regulator and the tow vehicle's charging all need to suit lithium.

We check the whole charge path first and fit a lithium battery with a battery management system (BMS) that protects the cells. Where an old charger would undercharge or overcharge it, we replace it.

Solar panels and regulators

Solar keeps the battery topped up at camp without running a generator. We fit roof panels and wire connections for portable panels, with an MPPT solar regulator matched to the panel size and battery type.

The regulator is as important as the panel. An MPPT unit collects more from the same panel than a basic one, especially in winter or when the sun is low. We size the cable so little is lost between the roof and the battery.

Off-grid power systems

For longer stays off-grid, we build a system around a larger battery bank, an inverter, a charger and a battery monitor. The monitor shows your state of charge, so you can see what the fridge and devices are drawing.

We fit gear from Victron and Enerdrive, among others, planned to the loads you actually run. Anything beyond the inverter on the 240V side is left to a licensed electrical contractor.

Camper trailers

Camper trailers need simpler setups, and often a lighter touch. A typical one is a single battery, an Anderson plug fed from the car for charging, and a compact solar panel.

We wire the Anderson plug on correctly sized cable with a fuse at each end, so the battery charges properly while you drive. We also add 12V and USB outlets where you will use them at camp.

How we sort out a caravan electrical problem

As a caravan auto electrician, we work from the tow vehicle to the van and test each stage in turn, so a fault is found in the right place the first time.

  1. Check the charge path

    We start at the car and follow the charge from plug to battery. That means the vehicle plug, the Anderson connection, any DC-DC charger and every fuse along the way, since charging faults usually sit in one of these.

  2. Test the battery and loads

    Next we test the battery's capacity and see what the fridge, lights and devices draw. A tired battery or an overloaded circuit can look like a charging fault, and a battery monitor makes the answer easy to see.

  3. Repair or upgrade

    Once we know the cause, we write up a quote for the fix or for a planned upgrade, and we explain the options. You approve the work before we start. If a part needs replacing, we say why.

  4. Test hitched up

    Finally, we test charging with the van connected to the tow vehicle, then confirm the solar is charging the battery. We do not finish until the system works the way you will use it on the road.

Want the fault found and the repair priced before any work starts?

Solar on the roof or portable panels?

Both work well, and plenty of travellers use a mix. The right choice depends on your van, where you camp and how much you want to handle each stop.

Fixed roof solar

Roof panels charge whenever the sun is up, with no setup at camp. They keep working on the drive and while the van sits parked at home, which helps the battery stay healthy between trips.

The limits are roof space and shade. A fixed panel cannot be moved out of the shade of a tree or an awning, so charging drops when you park under cover. Roof panels also add a little weight and need sealed cable entries.

Portable panels

Portable panels can be set in full sun while the van stays in the shade, and you can angle them toward the sun through the day. They suit camper trailers and vans with little roof space.

The trade-off is effort. You have to set them up, move them, pack them away and store them. They plug in through an Anderson connection, which we wire with proper cable and fusing, so the panel's output reaches the battery.

Caravan electrician in Bunbury: the WA 240V rule

Caravan electrics are split in two in WA. The 12V side, which covers batteries, solar, chargers and 12V circuits, is where we work. The 240V side is regulated.

Building and Energy (WA) says 240V wiring in a campervan or vehicle conversion must only be done by a licensed electrical worker employed by a licensed electrical contractor. A Perth renovator was fined in 2024 for doing it unlicensed.

Becoming a licensed electrical worker takes at least four years of training and experience, and licensed work comes with mandatory checks, tests and certification. That is why fixed 240V work goes to a licensed contractor, and we tell you which jobs those are.

Bunbury is a common base for caravan trips, with Forrest Highway running about 96 km north towards Perth. A long run north is a fair test of whether the van charges properly before you reach camp.

Safe 12V work in your van

A van carries a lot of stored energy and runs in tight spaces, so how the work is done matters. This is what you can expect at handover.

Fused and labelled circuits

Every circuit is fused at the source, close to the battery, so a fault trips a fuse instead of heating a cable. We label the fuse panel and switch panel, so you and any future electrician can see what each circuit does.

That makes later faults faster to trace, and it makes it safer to add accessories down the track.

Cable sized for the run

Caravans have long cable runs between the battery, the solar regulator and the loads. Thin cable drops voltage over distance, which means weak charging, dim lights and a fridge that struggles.

Each run is sized to the current and the distance, then sleeved in loom wherever it crosses cupboards, floors and chassis points.

240V left to licensed contractors

At handover we give you clear notes on what is 12V work and what is not. If your van needs fixed 240V wiring or a new 240V circuit, we tell you it is a job for a licensed electrical contractor.

That keeps the van legal, and it means each part of the system is done by someone licensed to do it.

What affects the cost of caravan electrical work?

Caravan repairs in Bunbury vary from one fuse to a full power system, so we quote after we see the van and hear how you travel. These factors have the most effect, and our free quote covers each one.

Fault vs upgrade

Finding and fixing a fault is a smaller job than building a new system. An upgrade also adds parts, wiring time and testing.

Battery capacity

A single battery costs less than a larger bank. More capacity means more cable, fusing and a bigger charger to match.

Solar size

The panel's wattage and the regulator that goes with it set the cost. Larger arrays need heavier cable and more roof work.

Access in the van

Tight cupboards and hidden cable runs take longer. Vans with clear access to the battery area and wiring are quicker to work on.

Caravan electrical FAQs

Why isn't my caravan battery charging while towing?

A caravan battery usually fails to charge while towing because of a fault between the car and the van. The common causes are a bad pin in the 12-pin trailer plug, a poor Anderson connection, a blown fuse or a DC-DC charger that is not getting power. On some newer vehicles the engine computer limits alternator output, which can also starve the van battery.

Why won't the power points work in my caravan?

Power points stop working because of a blown fuse, a flat battery or a fault in the circuit. First check whether they are 12V or 240V outlets. 240V faults are not DIY work, and in WA they go to a licensed electrical worker.

How do I know if a caravan fuse is blown?

You can tell a caravan fuse is blown by looking at it, testing it with a test light or checking it with a meter. A blown fuse often shows a broken wire or a dark mark inside. If it keeps blowing, something is drawing too much current, so find the cause before fitting another.

What do I need to run my caravan off grid?

To run a caravan off grid you need enough battery capacity for your loads, a way to recharge it, and a way to watch it. That usually means a battery, solar panels with a regulator, a charger from the tow vehicle, a battery monitor and an inverter if you run small appliances.

Should I upgrade my caravan to lithium batteries?

A lithium upgrade is worth it for many caravans, mainly for the weight saving and the extra usable capacity. It does need a charger, a solar regulator and a tow vehicle charging system that are compatible with lithium. We check the full charge path before we recommend it.

How much solar do I need for an off-grid caravan?

How much solar you need depends on your daily power use and the time of year. Add up what the fridge, lights, pump and devices use in a day, then size the panels to replace it in winter sun, not summer. We work this out with you before we quote.

Who can do 240V wiring in a caravan in WA?

Only a licensed electrical worker employed by a licensed electrical contractor can do 240V wiring in a caravan in WA. Building and Energy sets this rule, and unlicensed work can lead to a fine. We handle the 12V side and tell you when a job needs a licensed contractor for 240V.

Van not charging? Let's find out why

Get the van checked before your next trip, not at the campsite. Ring 08 6706 6760 or use the quote form and we will test the charge path from the car to the battery.