Mobile auto electrician across Bunbury, Australind, Eaton & DalyellupCar won't start? Call 08 6706 6760
BunburyMobile Auto Electrician
Menu

HomeServicesBatteries, Alternators & Starter Motors

Car Battery, Alternator & Starter Repairs in Bunbury, WA | Tested First

Three parts start a car and keep it running, and each can fail in a way that looks like another. The battery stores the power, the starter motor turns the engine over, and the alternator recharges the battery as you drive.

When one fails, the other two often take the blame, and that is how people end up buying a car battery in Bunbury they didn't need. An auto electrician in Bunbury should find the real fault first, so we test the whole starting and charging system before anything is replaced.

We start with a battery load test, then measure alternator output and check starter draw and cable voltage drop. Only then do we quote to repair or replace the part that has failed.

The work happens where the car is parked, at home or at work, so if you've searched for a car battery near me, the battery comes to you. Call 08 6706 6760 or use the free quote form and tell us what the car is doing.

Starting and charging work we do

Most starting and charging faults come down to a battery, an alternator, a starter motor or the cables between them. We test each one before quoting, so you pay to fix the part that has actually failed.

Battery testing and replacement

A battery that cranks slowly or won't hold charge needs a load test, not a guess. We test cranking ability and state of charge, then fit the right size and type for your vehicle: standard, EFB or AGM. Cars built with start-stop systems generally call for an EFB or AGM battery, so we match what the car was made to use.

Some cars also need the new battery registered with the battery management system so the charging strategy matches it. We check for that when we quote, and we take the old battery away with us.

Alternator repair and replacement

A battery light, dim headlights, a whine from the front of the engine or a battery that keeps going flat all point at the alternator. Inside it, the usual culprits are the voltage regulator, worn brushes, failed diodes and tired bearings. We measure output at idle and under load before deciding anything.

A regulator or set of brushes can often be repaired. A unit with bad bearings or burnt windings is usually better replaced, and we'll tell you which it is.

Starter motor repair and replacement

A single click, a grinding noise or a slow crank can mean the starter motor, but a weak battery or a corroded cable looks identical. We check current draw and voltage drop first. If the starter is at fault, the solenoid contacts and brushes are the common wear points and can often be rebuilt.

A starter with a worn housing or armature is better replaced, because the same fault comes back. Some sit low behind the exhaust or under the intake, which affects labour more than the part.

Cables, terminals and earths

Corroded battery terminals and loose or rusty earth straps cause plenty of no-starts that look like a dead battery. A terminal can look clean on top and be crusty underneath, and an earth strap can pass a continuity test and still drop volts while the engine cranks.

We measure voltage drop across the cables under cranking load, then clean, tighten or replace the terminals and straps. It's a small repair, and it saves buying a battery that was fine.

How we test a starting or charging fault

Every starting or charging job follows the same four checks, in order. That way the quote covers the part that failed, and the re-test proves the fix worked.

  1. Battery load test

    We test state of charge and cranking ability under load. A battery can show a healthy voltage at rest and still collapse the moment the starter pulls on it. A load tester shows whether it can still deliver the current the engine needs. We also note the battery type and look for a swollen or leaking case.

  2. Charging output check

    With the engine running, we measure alternator output at idle and again with headlights, blower and rear demister on. A healthy alternator holds a steady charging voltage under that load. Low or fluctuating voltage points at the alternator, its regulator or the drive belt, so we check belt condition too.

  3. Starter and cable draw

    We measure starter current draw while cranking, then voltage drop across the battery cables and earth strap. High draw suggests a tired starter. A big voltage drop points at a corroded terminal or earth. This check separates a faulty starter from a poor connection.

  4. Replace, repair and re-test

    You get a written quote for the part that failed, and we fit it once you've agreed. Afterwards we re-test the whole system: battery, charging voltage and starter draw. If the battery needs registering with the car, that's done before the keys go back to you.

Want the fault found and the repair priced before any work starts?

Repair, exchange or new?

Alternators and starter motors don't always need a new unit. The options are a repair, an exchange unit or a new part, and each has trade-offs in cost, time and how long the fix should last.

Repair the unit

Repair makes sense when the fault is a known wear part: alternator brushes, a voltage regulator, a starter solenoid or starter brushes. The unit stays original and the job is often the lower-cost option.

The trade-off is that the rest of the unit stays old. If the bearings, windings or armature are also worn, a repair can buy only a few months before something else lets go. We'll say so rather than patch it.

Exchange or new unit

A replacement is the better call when the housing, windings or bearings are worn, or when the repair would cost close to a unit anyway. Exchange units are rebuilt cores and usually suit older vehicles.

A new unit costs more but gives you fresh wear parts, which matters on a vehicle that works hard, such as a 4WD, ute or tow vehicle. Quality varies between suppliers, so we fit parts we'd be happy to put in our own vehicles and tell you what we've fitted.

Car battery and charging problems in Bunbury

Bunbury winters are cold enough to expose weak batteries. The mean minimum in July is 7.4 °C, and a car battery that's marginal in summer is often the one that won't crank on a cold morning.

Winter is also damp. Mean relative humidity at 3pm climbs to 64 to 66 per cent from June to September, which keeps moisture sitting on terminals and earth points. Bunbury sits at the southern end of the Leschenault Inlet, which opens to Koombana Bay. Salt in the air is a known cause of corroded terminals on cars kept near the coast.

Short trips don't help. A car that only does five minutes to the shops never fully recharges, so the battery runs a little flatter each week. If that's your driving, a charging check and a terminal clean-up are worth doing before the no-start, not after.

What you get with every battery or charging job

The same standard applies whichever part we fit.

Correct part for the vehicle

We match the battery or unit to the vehicle's specification, not just to what fits in the tray. That means the right capacity and cranking rating, the battery type the car was built for, and the correct alternator output for the electrical load. The right size with the wrong type can fail early and upset the charging system.

Whole system re-tested

Replacing one part can expose the next weak one, so we don't stop at the part we fitted. After the job we re-test the battery, alternator output and starter draw together, with the engine running and cranking. You get an honest read on the whole starting system, not a new part on top of an old problem.

Old units recycled

Used batteries contain lead and acid and shouldn't go in general rubbish. We take the old battery away with us, along with old alternator and starter cores. They go to recycling, not into your bin or the back of the shed. Where you've had an exchange unit, the old core is what gets sent back to be rebuilt.

What affects the cost of replacing an alternator or battery?

The price depends on the vehicle and the fault, which is why we don't publish a number that would be wrong for half the cars on the road. These four things move the quote most. Send your car's details through the free quote form and we'll price it.

Battery type

A standard battery costs less than an EFB or AGM. Start-stop vehicles and cars with heavy electrical loads call for the higher-spec types, so the battery your car needs sets the price.

Repair vs replacement

Rebuilding a regulator or set of brushes usually costs less than an exchange unit, and an exchange unit usually costs less than new. The right choice depends on what else is worn.

Engine access

Some alternators and starters sit in plain view. Others are buried under intake manifolds or behind other components. More dismantling means more labour, which is why starter motor replacement cost varies so much between vehicles.

Programming

Some vehicles need a new battery registered with the car's computer so charging is managed correctly. That adds a step to the job, and we build it into the quote.

Battery, alternator and starter FAQs

How do I tell if it's my starter or alternator?

You can usually tell whether it's the starter or the alternator by when the problem happens. If the engine won't crank, or only clicks or grinds, the starter, the battery or a cable is the likely cause. If the car starts but then dies, or the battery light comes on while you drive, suspect the alternator. A load test and charging check confirms which, so you don't replace the wrong part.

How do I tell if my car needs a new battery?

Your car needs a new battery if it cranks slowly, shows a battery warning, or fails a load test. Age matters too, because a battery that has been in the car for several years is closer to the end of its life. A voltage reading alone can mislead, so we test cranking ability under load before recommending a replacement.

Do car batteries give warning before dying?

Sometimes a car battery gives warning, but many fail suddenly with no symptoms at all. Slow cranking, dim lights at start-up or a clock that resets can come first, especially on cold mornings. A battery can pass a voltage check and still fail a load test, so testing is the only reliable way to know.

How many years should a car battery last?

A car battery's life depends on how the car is used as much as on its age, so we can only give a general guide. Many last several years. Short trips, heat, cold, heavy accessories and a parasitic draw that drains it overnight all shorten that. A load test tells you what's left in yours.

Can an alternator be repaired?

Yes, an alternator can often be repaired, depending on what has failed. A worn voltage regulator or set of brushes is a common, repairable fault, and bearings and diodes can also be replaced. If the windings or housing are badly worn, replacing the unit is usually the better outcome. We test output first, then tell you which option makes sense.

What are the first signs of a bad alternator?

The first signs of a bad alternator are usually a battery warning light, dim or flickering headlights and a battery that keeps going flat. You may also hear a whine from the front of the engine or smell something hot or burning. If you notice any of these, get the charging system tested before the car leaves you stranded.

What affects alternator replacement cost?

Alternator replacement cost depends on the vehicle, how hard the alternator is to reach, and whether you choose a repair, an exchange unit or a new one. A worn drive belt or tensioner found during the job can add to it, and some vehicles need extra programming. Send your car's details through the free quote form and we'll price the job.

Battery light on? Get it tested

Not sure which of the three has failed? Get it tested before you spend on parts. Ring 08 6706 6760 or fill in the quote form with what the car is doing.